Products Description
The 20 inch jumbo wound filter is designed for high-flow and high-impurity conditions. It achieves a 99.8% particle retention rate through a multi-layer gradient filtration structure, and its dirt holding capacity is more than three times that of conventional filter elements. It is suitable for harsh industrial scenarios such as chemical, electric power, and water treatment.

Technical parameters
| Parameter | Specification |
| Length | 20 inches (approx. 508 mm) |
| Outer Diameter (OD) | 4.5 inches (approx. 114 mm) – jumbo size |
| Inner Diameter (ID) | 1.1 inches (approx. 28 mm) |
| Micron Rating | 0.5 – 150 µm |
| Core Material | PP, Stainless Steel, or Tin Steel |
| Filter Media | Polypropylene, Cotton, or Glass Fiber |
| End Cap Type | DOE (Double Open End), SOE (Single Open End), etc. |
| Max Operating Temperature | 60–120°C |
| Flow Rate | Up to 40 – 80 GPM (depends on system design & fluid) |
| Recommended Change-out Differential Pressure | 1.0 – 1.5 bar |
features
✅ Deep gradient filtration
Gradual density fiber structure, surface interception of large particles, deep capture of submicron particles, pollution capacity increased by 320%.
✅ Anti-leakage design
Laser welded end cap + double-layer sealing ring to ensure zero leakage.
✅ Flow optimization structure
Wrapped guide groove design, flux up to 50 m³/h.
✅ Wide chemical compatibility
Resistant to strong acids and alkalis (PH 1-14), PTFE material can be customized for special working conditions, resistant to 98% concentrated sulfuric acid.
Real customer cases
▶ Cooling water system protection for chemical plants
- Pain point: Rust/sand causes heat exchanger blockage, monthly downtime for cleaning costs $18,000
- Solution: Install 20-inch 50μm jumbo wound filter (12 in parallel) on the main line
- Results:
✓ Filter life extended to 90 days (original filter replaced every 15 days)
✓ Heat exchanger cleaning cycle extended from 1 month to 6 months
✓ Annual maintenance cost savings of $216,000
▶ Ultrapure water pretreatment for semiconductor plants
- Challenge: Fluctuation of raw water turbidity causes frequent fouling of RO membranes
- Solution: 10μm string wound filter as a safety filter
- Data results:
✓ SDI value stabilized at <2.0 (original system 3.5-4.2)
✓ RO membrane chemical cleaning frequency reduced by 70%
✓ Water production qualification rate increased to 99.97%
workshop




Order information

Hot Tags: 20 inch jumbo wound filter, China 20 inch jumbo wound filter manufacturers, suppliers, factory, melt blown filter cartridge, pleated filter cartridge, string wound filter cartridge, filter bag, sintered metal filter cartridge, high flow filter cartridge



