Blog

Common faults and solutions of vacuum oil purifier

Dec 17, 2024 Leave a message

Vacuum oil purifiers are designed to remove solid contaminants and water from oil through advanced vacuum technology and filtration technology to improve fluid cleanliness. However, during long-term use, there will be some failures, which can lead to poor filtration performance or wear and tear of components. In this article, we list 5 common faults and solutions, hoping to help you.

 

1. The vacuum degree does not meet the technical standard

  • Cause of failure: too much water in the filtered oil; The place of use is at a different altitude and is not at standard atmospheric pressure; The vacuum oil in the vacuum pump is lower than the oil level line; Vacuum oil lasts a long time and contains a lot of water; Seal leakage at each connection; Wear and tear of vacuum pump consumables.
  • Solution: Increase the number of filtration, increase the temperature of the oil, and evaporate the water; Replace the oil with new one; Check the tightness; Replacement of wearing parts.

 

2. The pressureless oil output of the oil discharge pump is insufficient

  • Cause of failure: Blockage of the filter element of the primary filter; Leakage of oil seal of oil drain pump; The suction tube is too thin; The small hole of oil injection in the vacuum tank is blocked.
  • Solution: Clean or replace the filter element; Adjust the oil seal gland or replace the oil seal; Clean the vacuum tank.

 

3. Vacuum pump oil injection

  • Cause of failure: the water content of the filtered oil is large, the oil floats up and is sucked into the vacuum pump, and the oil level of the vacuum pump rises; The gasket in the vacuum pump is displaced or damaged.
  • Solution: The vacuum oil cannot be higher than the oil level; Check the gasket.

 

4. The oil control is ineffective or does not display the temperature

  • Cause of failure: oil temperature and thermometer do not stop; The heater burned out; The line is disconnected.
  • Solution: Adjust the oil control; replace the heater; Repair lines.

 

5. Under normal working conditions, the pressure is greater than 0.3MPa

  • Cause of failure: the oil outlet pipe of the machine is too long, the oil level of the pipeline is too high, the oil outlet diameter is small or the pipe is too small; The oil filter element is clogged or worn.
  • Solution: Change the work environment; Clean or replace the oil filter element.

 

The above are several common faults and solutions of vacuum oil purifiers. If you have other questions or want to have more in-depth technical exchanges, please feel free to contact us!

Send Inquiry